Ranking TOP19 Carbon Monoxide CO Alarm CUZMAK Display Digital Detector Alarm,/dressy754273.html,Digital,$14,remcuahoanganh.com,Monoxide,Detector,,Display,Carbon,CUZMAK,Carbon,CO,Tools Home Improvement , Safety Security , Fire Safety Alarm,/dressy754273.html,Digital,$14,remcuahoanganh.com,Monoxide,Detector,,Display,Carbon,CUZMAK,Carbon,CO,Tools Home Improvement , Safety Security , Fire Safety $14 Carbon Monoxide CO Alarm Detector, CUZMAK Digital Display Carbon Tools Home Improvement Safety Security Fire Safety Ranking TOP19 Carbon Monoxide CO Alarm CUZMAK Display Digital Detector $14 Carbon Monoxide CO Alarm Detector, CUZMAK Digital Display Carbon Tools Home Improvement Safety Security Fire Safety

Ranking TOP19 Carbon Monoxide CO San Francisco Mall Alarm CUZMAK Display Digital Detector

Carbon Monoxide CO Alarm Detector, CUZMAK Digital Display Carbon

$14

Carbon Monoxide CO Alarm Detector, CUZMAK Digital Display Carbon

|||

Product Description

  • It is suitable for all the Place Possible to Produce Carbon Monoxide

It is suitable for all the Place Possible to Produce Carbon Monoxide, Such as your Home Kitchen, Bedroom, Bathroom, Hotel, office, shcool, warehouse, hospital... Also Useful When you are Enjoying the Barbecue, Using Charcoal Warm yourself, or Putting it in your Parking Garage, etc.

  • Features

  1. Strong 85 decibel alert.
  2. Permanent carbon monoxide sensor.
  3. The alarm sound mode is four short beeps. Red LED flashes in alarm mode.
  4. beep sounds every 30 seconds, indicating that the battery is low (need to be replaced) (green LED flashes every 30 seconds).
  5. Test/reset button for testing the electronic components of the device, checking the correct operation of the device, and resetting/silence the device during the Co alarm.
  6. Alarm memory function: If the device never alarms, press the button, the green LED will flash once every second for one minute, and the peak alarm level will be displayed on the LCD.

  • Test the alarm First, HOW TO TEST IT(3 steps):

  1. Step 1: Install the batteries in clean air, then press the test button for five seconds to test the units electronics, beeps will sound if it's normal;
  2. "li"Step 2: Leave it in clean air for one minute; "li"Step 3: Then put it into a sealed bag, spray some CO gas into the bag and seal it. Waiting for about one minute, the Alarm will go off if it's normal.

[NOTE: DO NOT test it by directly burning something under this alarm, which is an invalid test.]

  • HOW TO SILENCE THE ALARM

Only when detected clear air can it silence the alarm(if the room still exists high level of CO the alarm will keep alarming until the air was cleaned)

  • Throughly Read This Below:

  1. This carbon monoxide alarm is only designed to detect/alarm carbon monoxide gas to protect your family from the dangers of carbon monoxide. It is Not designed for Smoke detection or any other gas detection. Battery-operated alarm that includes a blue back light digital display feature.
  2. Don't press test/reset button while installing batteries. Otherwise, the unit will not work.
  3. "li"Before installing the Carbon Monoxide Detector, the batteries must be removed, stripped of their plastic jackets and then reinserted in the Carbon Monoxide Detector. "li""u"NOTE: IN NORMAL CONDITION, LCD IS NOT LIT FOR SAVING ENERGY( ENTER THE STANDBY STATE, IT JUST LIKES OUR PHONES). LCD WILL BE LIT TO DISPLAY THE ACTUAL CONCENTRATION AS CO CONCENTRATION EXCEEDS 30PPM OR AS THE TEST/RESET BUTTON PRESSED, LCD Display does not lit when CO CONCENTRATION less than 30 PPM. "li"The CO Detector needs to be tested weekly.
carbon monoxide co detector alarm"noscript"carbon monoxide co detector alarm

    "li"Test the alarm First:

Step 1: press the test button for 5s (A single silence and test button eliminates confusion and allows you to silence and test the alarm easily)

Step 2: the unit will sound 4 beeps every 5s twice amp; Red LED flashes amp; LCD display "000" (3 min), that shows the unit in a normal situation.

    "li"Low Power warning:

Carbon Monoxide Alarm alerts you to dangerous carbon monoxide,even in the event of a power outage. IF the alarm is low power,you can find the situation:

Sound:"Chirp" every 30s; LED: Green LED flashes once every 30s amp; Red LED is flashes; LCD Display: "Ld"

    "li"Malfunctioning warning: IF the Carbon Monoxide Alarm does not work well,you can find the situation

Sound: "Chirp" every 30s; LED: Green LED is not flashes and Red LED is flashes; LCD Display: "Err"

    "li"Leaked: This carbon monoxide detector features a digital display that shows the carbon monoxide level in the room, as well as the unit’s power level.

"u"A. level over 999ppm:

Sound: 4 short alarm beeps; LED: Red LED is flashes; LCD Display: "999ppm"

"u"B. 30ppm< level< 999ppm

Sound: 4 short alarm beeps; LED: Red LED is flashes; LCD Display: "real timel concentration"

"u"C. level Less then 30 PPM:"u" LCD Display does not lit when CO CONCENTRATION less than 30 PPM.

Carbon Monoxide CO Alarm Detector, CUZMAK Digital Display Carbon

  • Product

  • Solutions

  • Templates

  • Learn

  • Pricing

Say goodbye to dull documents, dry data and confusing communications with Venngage — the infographic design solution.

Sign up for free

Trusted by

Better communication in 3 easy steps

Not a designer? Not a problem with Venngage.

7,500+ professional templates

Pick a pre-made infographic template or create your own.

Powerful, easy to use editor

Drag and drop icons, photos, text and charts into your infographic.

Share and download

Download and share your infographics or invite your team to collaborate.

Professional infographic templates for every team

Smart features, beautiful infographics.

Better communication is possible, no design experience is required

Automated Branding

Collaboration

Data Visualization

Smart Features

Diverse Icons & Photos

24/7 Online Support

Start creating better infographics with Venngage today